The AutoSperm system has been discontinued. These pages are for documentation only.

Setup: final steps

Test the hardware

After the digitizing tablet has been connected to the computer, you complete the following steps:

  • Select Options in the Tools menu.
  • Click the Tablet tab.
  • Select the tablet type (SummaSketch III, DrawingBoard III or DrawingBoard VI)
  • Select the communication port the tablet is connected to (usually 1 or 2).
  • Click the Test button (see Test tablet)

Calibrate the system

Create AutoSperm users

Since as an administrator you cannot perform semen analyses in the AutoSperm system, you must create one or more AutoSperm users (technicians).

To create a new user:

  • Select Users in the Tools menu.
  • Click the New button.
  • Complete the panel as explained on User data.
Privacy policy Contact Site map