The AutoSperm system has been discontinued. These pages are for documentation only.

AutoSperm software installation

You install the software by executing the program autospermsetup.exe. During installation, you will see the following panels:


Welcome to AutoSperm wizard


After some initialization, this Welcome panel appears. Click Next.
Configure shortcuts


Select the locations of different shortcuts to the AutoSperm program. Click Next.
Select installation folder


Select the location of the AutoSperm program files. It is recommended to accept the default value. Click Next.
Ready to install


The installation program is now ready to install AutoSperm. Click Install.
Installing AutoSperm


This panel shows the installation status..
Setup completed


Installation is complete. The Launch AutoSperm option is checked by default. You are now ready to run AutoSperm for the first time. Click Finish.

Next step

Privacy policy Contact Site map