The AutoSperm system has been discontinued. These pages are for documentation only.

How to connect the DrawingBoard VI tablet

All cable connections are made at the rear of the tablet. Turn off your computer and make sure the tablet power switch is in the off position.

DrawingBoard VI connections

  1. Connect the cursor to the appropriate jack on the digitizer's Connector Panel. The connector is keyed and will only fit the correct jack. Do not force it.
  2. Connect the RS232 serial cable to the serial jack on the Connector Panel. The connector will fit only the correct jack. Connect the 9-pin connector of the serial cable to the serial port on your computer.
  3. Plug the power supply into an AC outlet. Connect the power supply to the appropriate jack on the Connector Panel. Turn the Power Switch on. The light on the cursor will turn on.

Next step

Privacy policy Contact Site map